Set ip address of cisco 2950 switch how to#
Set ip address of cisco 2950 switch serial#
Set ip address of cisco 2950 switch password#

Set ip address of cisco 2950 switch password#

Type in the enable command to enter privileged EXEC mode (you donвЂ™t need a password at this stage because youвЂ™re under the default configurations which donвЂ™t have one!): Enable Enter Privileged EXEC Mode and Set a Hostname for the Switch The following message will display in the command prompt: Switch> 2. Press the Open button at the bottom of the page to launch the CLI.Click the Save button to store the settings.Go to the Saved Session field and enter a name for your settings e.g.Click on the Session option from the Category list on the left-hand side of the page.To save your PuTTY settings for your next session do the following: Save Your Settings and Start the PuTTY CLI Go to the Flow Control drop-down menu and select the None option.Click on the Parity drop-down menu and select the None option.Now go to the Stops bits field and enter 1.For 300 and 500 Series Managed Switches, this is 115200. Next, enter the digital transmission speed of your switch model.

Set ip address of cisco 2950 switch serial#

When the options controlling local serial lines page displays enter the COM port your network is connected to in the Serial line to connect to box e.g.

Go to the Category list section on the left-hand side and select the Serial option.

Go to the Connection type settings and check the Serial option (shown below).

Now open PuTTY and the PuTTY Configuration window will display.

Connect the switch to PuTTY with a 9-pin serial cable.

To start configuration, you want to connect the switch console to PuTTY. If for any reason putty is not an option for your setup, you can get similar results with a PuTTY alternative. In this guide, weвЂ™re going to perform a Cisco switch configuration through the command-line interface (CLI) with the open-source SSH/Telnet client PuTTY (although you can use another tool if you prefer). Now that youвЂ™ve made sure the device is in working order youвЂ™re ready to start configuring. You can turn the router on to make sure there is no damage to the lighting/indicators. You also want to check the physical state of the device and verify that none of the cables are damaged. If youвЂ™re using a Cisco switch you need to know what model you have. The first step is to check what hardware youвЂ™re using before you begin. Getting Started with Cisco Switch Commands Before we begin, get to know what hardware youвЂ™re using, fire up your CLI and download PuTTY.

Set ip address of cisco 2950 switch how to#

Cisco is one of the most well-known switch vendors on the market and in this article, weвЂ™re going to look at how to configure Cisco switches with PuTTY and from the command-line.

Switches can take incoming/outgoing traffic and pass it onward toward its final destination.

When we think of connectivity in a network, the router is probably the first device that comes to mind, but switches play a vital role in enabling network devices to communicate.